Toshiba B-443 - page 27

EO1-33013

3.8 Dump Mode

After the self test, the printer enters the dump mode. In this mode, any

characters sent from the host computer will be printed in two columns, as shown.

The characters received will be shown in the first column, and their

corresponding hexadecimal values, in the second. This is often helpful to users

for the verification of programming commands or debugging of printer programs.

Reset the printer by turning the POWER switch off and on.

Contents

Main LIST OF STANDARDS OF CONFORMITY Page CONTENTS 1. PRODUCT INTRODUCTION................................................................ 1 2. GETTING STARTED............................................................................. 2 5. SPECIFICATIONS, OPTIONS, & SUPPLIES .................................... 25 Page Safety Summary WARNING This indicates that there is the risk of death or serious injury if the Meanings of Each Symbol CAUTION Precautions Request Regarding Maintenance 1. PRODUCT INTRODUCTION 1.1 Compliances 2. GETTING STARTED 2.1 Applicable Model 2.2 Unpacking and Inspection 2.3 Equipment Checklist Page 2.4 Printer Parts Page Page Page 2.6 Buttons and Indicators 3. SET UP 3.1 Setting Up the Printer 3.2 Loading Label and Tag Stock Page Page 3.3 Self-Peeling Function Page 3.4 Ribbon Loading Instructions Page Page 3.5 Install External Label Roll Mount 3.6 Install Memory Module 3.7 Self Test Page 4. USING B-443 4.1 Power-on Utilities 4.1.1 Self Test Utility 4.1.2 Gap Sensor Calibration Utility 4.1.3 Printer Initialization Parameter Default Value Cleared by Initialization 4.2 Error Messages 4.3 Troubleshooting Guide 5. SPECIFICATIONS, OPTIONS, & SUPPLIES 5.1 Specifications 5.1.1 Printer 5.1.2 Indicators and Buttons 5.1.3 Communication Interface 5.2 Options 5.3 Supplies 5.3.1 Label Stock 5.3.2 Ribbon