Toshiba B-450-QQ Series owner manual Threshold Setting, Pause

9. THRESHOLD SETTING

EO1-33006

9. THRESHOLD SETTING

9. THRESHOLD SETTING

For the printer to maintain a constant print position it uses the transmissive sensor to measure the amount of light passing through the gap between labels. When the paper is pre-printed, the darker (or more dense) inks can interfere with this process causing paper jam errors. To eliminate this problem a minimum threshold can be set for the sensor in the following way.

Power OFF

DIPSW

6	7	8
ON	OFF	ON

(1)The power is off.

(2)Set the DIP switches to enter the manual threshold setting mode.

[FEED]

Power ON

Power Online Error

[FEED]

Power Online Error

(3)Turn the power ON while pressing and holding the [FEED] key.

The transmissive sensor is selected.

(4)Press the [FEED] key.

The reflective sensor is selected.

The sensor type is switched by pressing the [FEED] key. Load the pre-printed label roll in the usual way.

[PAUSE]

Power Online Error

(5)Press and hold the [PAUSE] key.

The paper will feed through the printer until the [PAUSE] key is released. Release the [PAUSE] key after more than 1.5 labels have been fed.

(Threshold setting is completed by this operation.)

: ON

(6) Turn the power OFF.

: OFF : BLINK

NOTES: 1. To set the threshold properly, be sure to feed more than 1.5 labels. Insufficient paper feeding may result in an incorrect threshold setting. In this case, repeat the procedure.

2.While the print head is raised, the [PAUSE] key does not work.

3.If the paper runs out or a cutter error occurs, it will not be detected during the paper feed.

4.If the printer does not print in the correct position even after the threshold setting, the transmissive sensor adjustment may be wrong. In this case, re-adjust the transmissive sensor, and then set the threshold again. (When the backing paper is thick, the transmissive sensor adjustment is required.)

9-1