3 Diagnostic Programs 3.7 Storage
LBA Start, LBA End--Specify the start and end byte in LBA (Large Blo
Address). ck
Time Limit(h): Choose or Input the time (hour) of the defined range of the total
ted.
(1) Read & Write –Write data on the disk, then read it out and compare the two
(3) Unprotected Write—Write data on the disk without backup original data.
Option—Select sequential test or random test
2. Sequential/Random Seek
The test item is to check the correctness of the HDD’s sector’s seeking function.
This test item involves the following parameters:
Percent—Specify the coverage rate in percentage of the total disk.
disk to be tested.
Time Limit(m): Choose or Input the time (minute) of the defined range of the
total disk to be tes
Test Mode—Choose test mode from the following options:
value;
(2) Read Verify —Read data only;
IDE HDD Test Range—is same as the description of the upper item
LBA Start, LBA End-- specify start and finish byte in LBA(Large Block
.
Address);
42
Satellite/Satellite Pro/C650/C655 Maintenance Manual