4 Replacement Procedures 4.15 LCD Module (CCFL panel)
Installing the LCD Module
NOTE: LCD/FL cable must be carefully peeled away before disconnecting it from the
module.
Install the LCD module according to the following procedures and Figures 4-25, 4-26.
1. Turn the LCD upside down.
2. Connect the LCD/FL cable to the LCD module connector.
3. Turn the LCD right side up.
4. Place the LCD bracket in the correct position and secure it with two M2.5x5 black
flat head screws on each side.
5. Please the LCD module in the correct position and secure it with one M2.5x5 black
flat heat screws on each side.
6. Connect CCD cable to CCD module.
CAUTION: When installing the LCD module, please follow below instruction:
When plug in LCD/FL cable into LCD module connector, need to plug horizontally. For
Sharp panel, if LCD/FL cable connector is not plugged horizontally, it may be damaged.
4--42 Satellite/Satellite Pro/C650/C655 Maintenance Manual