4. PART NAMES & FUNCTIONS :
Knockout
Cut with a knife or scissors and insert the cables through the knockout so the cables will not pinched when installed.
"Bottom" mark
The "Bottom" mark indicates the lens position. The "Bottom" mark should be on the top when installing in a ceiling.
Power Input Cable
Connect the power cable to AC24V or DC12V. (RED:+12, Black:GND)
VIDEO Cable (BNC Tap)
Connect the Video Cable to a monitor or video device. The image is outputted when powered on.
Zoom Lever
Changes the picture range. Its screw design allows locking capability.
Focus Lever
Adjusts the image into focus. Its screw design allows locking capability.
Lens Iris ADJ
Use to compensate for the iris level. Turn towards L (low) for a darker picture. Turn towards H (high) for a brighter picture. Optimum value is adjusted at the default setting.
V Phase ADJ
Adjusts the phase difference between this camera and other cameras when in Line Lock mode.
Installation Holes
Installs camera to ceiling with attached screws.
Lens ADJ Screw
Turn the
Mode Setting Switch
1:BLC (Backlight Compensation Control) When switched on, it automatically adjusts to compensate for subjects that are lit from behind.
2:AGC (Auto Gain Control) When switched on, it automatically adjusts the image in relation to the brightness of the subject.
3:DC/AES
Not available for this camera. Be sure to switch to ON.
4: LL (Line Lock)
Use this switch to set the camera synchronization to internal or line lock. Line Lock is available with AC24V only.
Tilt ADJ Screws
Turn the screws to adjust the lens tilt angle. Fasten and lock them after the adjustment completes.
- 4 -
