4.1 General 4 Replacement Procedures
4 1
4.1 General This chapter explains how to disassemble the computer and replace Field Replaceable Units
(FRUs). Some replacement procedures may not require you to remove all the surrounding
FRUs to replace only one FRU. The chart below shows the FRUs in the order in which they
should be removed in a top-down manner, irrespective of their physical locations. The FRUs
shown in the top area of the chart should normally be removed before removing the FRUs
shown in the bottom area. To replace the FRUs, first identify the suspect FRU for the system
failure. Next, according to this chart, determine the FRUs that need to be removed before
removing the suspect FRU. After you determine those FRUs, go to the appropriate sections
according to the section numbers shown in the boxes. Then start removal and replacement.
4.8
TopCover
4.2
BatteryPack
BridgeMedia
4.3
MemoryModule
4.15
CCDboard and MIC
4.6
Keyboard
4.4
Card reader board
and DC IN cable
4.16
4.11
HDD
4.19
Thermal module
4.5
4.13
DisplayMask
4.17
Speakers
4.14
LCDModule
ODDBay Module
4.7
WirelessLAN Card
4.9
DisplayAssembly
4.10
SystemBoard
Switchbord and
bottonboard
4.18
4.12
CPU
Power board
Satellite/Satellite Pro/L630/L635 Maintenance Manual 4-1
4.8
TopCover
4.2 BatteryPack
BridgeMedia
4.3
MemoryModule
4.15
CCDboard and MIC
4.6
Keyboard
4.4
Card reader board
and DC IN cable
4.16
4.11
HDD
4.19
Thermal module
4.5
4.13
DisplayMask
4.17
Speakers
4.14
LCDModule
ODDBay Module
4.7
WirelessLAN Card
4.9
DisplayAssembly
4.10
SystemBoard
Switchbord and
bottonboard
4.18
4.12
CPU Power board
How to use the chart (two examples):
• For removing the System Board:
First, remove the top cover with the
display assembly. Then, remove the
HDD, selectable bay module,
Bluetooth card, keyboard, and
wireless LAN card, all of which are
shown above the top cover with the
display assembly.
• For removing the LCD Module:
First, remove the display mask and
FL inverter board, both of which are
shown above the LCD module.