Toshiba Utilities

187

Fingerprint Authentication Utility

4If other fingerprint data is still displayed on the list, hold down the Control key and select each fingerprint until they are all selected, then click Remove.

5Click OK to make the changes permanent.

6Check that all Fingerprint data was deleted on the Fingerprint Storage Inspector screen.

Care and maintenance of your fingerprint reader

Failure to follow these guidelines and/or procedures might result in damage to the reader or cause reader failure, finger recognition problems, or lower finger recognition success rate.

Do not scratch or poke the reader with your nails or any hard or sharp objects.

Do not press the reader with too much pressure.

Do not touch the reader with a wet finger or any wet objects. Keep reader surface dry and free of water vapor.

Do not touch the reader with a soiled finger. Minute foreign particles on a soiled or dirty finger may scratch the reader.

Do not paste stickers or write on the reader.

Do not touch the reader with a finger or any object with built-up static electricity.

Observe the following before you swipe your finger on the reader, whether for fingerprint enrollment/registration or recognition.

Wash and dry your hands thoroughly.

Remove static electricity from your fingers by touching any metal surface. Static electricity is a common cause of reader failures, especially during dry seasons such as winter.

Clean the reader with a lint-free cloth. Do not use detergent to clean the reader.