INTERFACES
FREQUENTLY ASKED QUESTIONS | 9 | ||
|
|
|
|
No: | Question | Answer |
|
1 | When and | The horizontal position control | |
| why do I | dial enables or disables the |
|
| need to | control of the horizontal |
|
| use the | position of the image. First |
|
| horizontal | adjust the horizontal position |
|
| position | using the monitor or projector | |
| dial? | control, and then use the |
|
|
| horizontal position control of |
|
|
| the VA6822, if needed. |
|
2 | What dip- | The first option is to take the |
|
| switch do I | output from RED, GREEN, |
|
| set to | BLUE & CSYNC connectors |
|
| receive | regardless of the |
|
| composite | settings. The second option is | |
| SYNC | to turn OFF the H&V Output |
|
| output? | ||
|
| from RED, GREEN, BLUE, |
|
|
| and HSYNC connectors. |
|
3 | When and | The VA6822 does not |
|
| why would | separate the sync signal from | |
| I use the | green, but if the desired output | |
| Sync on | is in RGsB format when the |
|
| Green dip- | input signal is RGBS or |
|
| switch, | RGBHV, then turn the sync on | |
| although | green dip switch to the ON |
|
| the unit | position. The VA6822 |
|
| does not | combines Sync on Green if |
|
| separate | this switch is in the ON |
|
| Sync from | position. |
|
| Green? |
|
|
4 | When do I | If the desired output is in |
|
| use the | RGBHV format, then turn ON | |
| H&V Out | the H&V Out | |
| H&V Out |
| |
|
| then composite sync may be |
|
|
| present on the HSYNC |
|
|
| connector. |
|
TROUBLESHOOTING GUIDE | 10 |
1.The power LED should turn RED when the correct voltage is applied to the Interface. It should turn GREEN when both power and a valid input signal is applied. If the power LED is absent when the unit is turned ON, return the VA6822 to the factory for repair.
2.Make sure the cables have the correct
3.Make sure that the source and display are
4.If the desired output is in RGBS format, then the H&V Output
5.If the desired output is RGsB, then the SYNC ON GREEN
6.If the image bends on top of the screen and RGBHV output is used, then turn on the H&V Output
7.Please make sure that the amplitude level of the input signal is as follows:
a)RED, GREEN, and BLUE channels are less than 1.2Volts
b)HSYNC & VSYNC are less than 5.0 volts
8.Please use only an ALTINEX supplied power cord suitable to the country of usage for proper operation of the VA6822.
9.If problems show up on the display after continuous usage at higher voltage, higher temperature, higher humidity, or at other extreme environmental conditions, please correct those extreme conditions.
12
12