INTERFACES
INSTALLING YOUR INTERFACE | 6 |
Step 1. Please attach the VA6822 Interface on the rack using the provided rack mount hardware or on/under furniture using the optional TM Series ALTINEX brackets.
Step 2. Connect one end of the input cable to the video output connector of the source computer and the other end to the computer input port of the VA6822.
Step 3. Connect an audio input cable’s 3.5mm plug to the audio output of a source computer and the other end to the audio input connector of the VA6822. If needed, use a similar cable to connect the audio output of the VA6822 to a speaker or audio equipment.
Step 4. Connect the local monitor output connector of the VA6822 to a local monitor or display using the appropriate ALTINEX Local Monitor cables. It is not necessary to terminate this output with a termination plug if a local monitor is not being used.
Step 5. Connect one end of a coaxial cable to the main output of the VA6822 and the other end to the RGBHV/RGBS input on the projector or monitor. Usually either a 4 BNC or 5 BNC coaxial cable is used, depending on whether the display devices require composite sync (RGBS) or separate horizontal and vertical sync (RGBHV) signals.
Step 6. Connect the main audio output from the VA6822 through the provided
Step 7. Make sure that the dip- switches are set as described in section 7.
Step 8. Using the provided power cable for your country of usage, connect the power input IEC connector to the AC wall outlet. The power supply used in the VA6822 is universal so it can accept from 100 VAC
9
to 240 VAC 50/60Hz. It is not necessary to change any voltage selection settings on the VA6822. The LED on the front and back panel of the VA6822 will light GREEN if the appropriate input signal is present and will remain RED if a valid input is not detected.
Step 9. It is recommended that you move the VA6822’s horizontal position dial to the far right facing the front until it clicks. This will disable the movement of the horizontal position of the image. The horizontal position of the image should first be adjusted using the control provided by the monitor or projector. If further adjustments are still required, then image can be adjusted using the horizontal position control dial located on the front of the VA6822.
Step 10. Adjust the equalization channels for the Red, Green, and Blue channels to get the best possible image on the display. It is recommended to increase equalization on all three channels simultaneously until the picture is perfect.
9
