4.16 Video board 4 Replacement Procedures
4. Remove the video board from the slot of the base assembly.
Video board
Figure 4-29 Removing the video board
Installing the Video board
To install the video board, follow the steps below and refer to Figure 4-28 to 4-29.
1. Connect the video cable to the connector CN9610 on the video board.
2. Install the video board in the slot of the base assembly.
3. Connect the video cable to the connector CN9600 on the system board.
4. Install the video cable holder while hooking the latches.
TECRA M5 Maintenance Manual (960-542) [CONFIDENTIAL] 4-45