Introduction
Inserting batteries
1 Slide the battery compartment cover in the direction of the arrow.
2 Install two “AAA” batteries | 3 Replace the compartment |
(supplied), paying attention to | cover. |
the polarity diagram in the |
|
battery compartment. |
|
Operation
•Aim the remote control at the remote sensor and press control buttons to operate.
•Operate the remote control within 30° angle on either side of the remote sensor, up to a distance of approx. 5 meters.
Approx. 5 meters
The precautions below should be followed when using batteries in this device:
1.Use only the size and type of batteries specified.
2.Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed batteries may cause damage to the device.
3.Do not mix different types of batteries together (e.g. Alkaline and
4.If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage.
5.Do not try to recharge batteries not intended to be recharged; they can overheat and rupture (follow battery manufacturer’s directions).
12
5K50201A [E] | 12 |
20/4/04, 15:41
