Toshiba MW20FP3, MW24FP3 Timer recording, Example, Press or to select Timer REC SET, then press

Recording (VCR)

Timer recording

Timer recording can be programmed on-screen with the remote control. The built-in timer allows automatic unattended recording of up to 8 programs within 1 month.

TV/VCR

TIMER REC

MENU ENTER

Timer recording

Preparation:

•Press TV/VCR to select the TV/VCR mode.

•Load a cassette tape with the erase prevention tab intact.

•Check the time and date are correct 21 .

Example:

Program a timer recording for 23rd day, channel 125 (Cable TV), 7:00 - 9:30 PM (Tape speed : SLP).

1 Press MENU, then press or to select option.

	TIMER REC SET
MENU	AUTO REPEAT	OFF
	ENTER
SETUP
	/ / / / MENU

5 Set the start time, end time, channel and tape speed as in step 4.

Then press ENTER.

		TIMER REC SET
			DATE			23(THU)
			START			7:00PM
ENTER			END			9:30PM
			CH		125
			SPEED			SLP
		/ /		/	/ ENTER/MENU
Notes:
• Press	to move cursor backward	2 3 T H		7 : 0 0 P M 9 : 3 0 P M 1 2 5 S L P

for correction.

• To record from external source set the channel to “L1” or “L2”.

// ENTER/CANCEL/MENU

2 Press or to select “TIMER REC SET”, then press .

TIMER REC SET

AUTO REPEAT OFF

ENTER

// / MENU

3 Press or to select one of the program line, then press ENTER.

ENTER

4 Press or to select the date, then press .

	TIMER REC SET
		DATE		2	3(THU)
ENTER		START			8:3 0AM
		END		— — :— —
		CH	0 1		2
		SPEED		S P
	/ / /		/ MENU

6 To set the timer for another program, repeat steps 3 to 5 to set another program.

Press both TIMER REC at the same time. The

7 TIMER REC indicator will light. The Timer is programed, when the programed time is reached, the recording is automatically started.

TIMER	TIMER	REC To cancel timer recording, press
REC			both the buttons again and TIMER
			REC indicator will go out.

Notes:

•The VCR section cannot be used while the TIMER REC in- dicator is lit. If you want to use the VCR operation,press both TIMER REC buttons at the same time to deactivate the timer.

•When the clock is not set, you cannot select “TIMER REC”. In this case, set the clock (see pages 19~21).

•After a power failure or disconnection of the power plug,all programmed recording setting and time display will be lost upon resumption of power. In this case, reset the clock (see pages 19~21) and reprogram any timer recordings.

•If you want to correct the digits while setting, press or

until the item you want to correct, then press or to correct the desired setting.

•If programming is performed without a tape in the unit, or with a tape without an erase prevention tab, the Timer Re- cording is not possible. If a tape without an erase prevention tab is in the unit, the tape will be ejected.

40

5L00301C [E]p38-41 40

20/4/04, 16:15