OSD ( On Screen Display ) Control page
Language selection page | Factory Reset page |
Only ‘English’ selection is available. | When all reset is necessary, this is the page to reset. |
The Light Sensor is placed at the power indicator area, also, wireless remote control receiver is located at the same place.
The purpose of this light sensor is to check the environment light level. If the area was dark, then, display Brightness may not be so much brighter compared to the bright noon time.
Light sensor selection is to make
Light Sensor Value adjustment works as to control the picture brightness when after the light sensor worked. Setting this value ‘higher’ will result the intensity high and ‘lower’ the value will come down low brightness in result. The original default value is at 25.
23
