ProblemProcedure
USB device does not Remove the USB device from the computer and
workthen reconnect it to a free port in order to ensure it is firmly attached.
Ensure that any required USB device drivers are properly installed - to achieve this you should refer to both the device documentation and the operating system documentation.
Sleep and Charge function
For more information and settings, please refer to the USB Sleep and Charge section.
Problem | Procedure | |
I cannot use the | Sleep and Charge function may be disabled. | |
Sleep and Charge | Enable the Sleep and Charge function in the | |
function. | ||
TOSHIBA System Settings. | ||
| ||
| When there is a current overflow of the external | |
| device connected to the compatible port, USB bus | |
| power (DC5V) supply may be stopped for safety | |
| reasons. When this happens, disconnect an | |
| external device if some external devices are | |
| connected. After that, turn the power of the | |
| computer ON/OFF to restore the function. If this | |
| function can not be still used even if only one | |
| external device is connected, stop using the | |
| external device because its current is over the | |
| acceptable value of this computer. | |
| Some external devices may not be able to use the | |
| Sleep and Charge function. In this case, please try | |
| one or more of the following methods. | |
| Turn OFF the computer while external devices | |
| are connected. | |
| Connect external devices after turning OFF of | |
| the computer. | |
| If this function can not be still used, change the | |
| setting to disable the function and stop using this | |
| function. | |
|
| |
The battery depletes | If Sleep and Charge function is enabled, the | |
quickly even when I | computer's battery will discharge during | |
turned OFF the | hibernation or when the computer is turned off. | |
power of the | Connect the AC adaptor to the computer or disable | |
computer. | ||
the Sleep and Charge function. | ||
| ||
|
|
User's Manual |