High-Wall Type Owner’s Manual
–23–
Toshiba

Operation section

Push each button to select a desired operation.
• The control saves commands in memory and after the initial setting, there is no need for any additional
settings unless changes are desired. The air conditioner can be operated by pushing the
button.
1 button
Selects the desired Fan speed.
2 button
Use to setup the timer.
3 button
Use only for service.
(During normal operation, do not use this button.)
4 button
Use when a power ventilation kit (commercially-
supplied) is connected.
• If “ ” is displayed on the remote control when
pushing the Ventilation button, no vent kit
connected.
5 button
Resets “ ” display after cleaning filter.
6 button
Use to initiate power saving mode.
7 button
Use to select automatic swing or fixed louver
position.
8Operation lamp
Green light illuminates when unit is on.
Although it flashes when operating the protection
device or an error occurs.
9 button
When the button is pushed, the operation starts, and
it stops by pushing the button again.
When the operation has stopped, the operation lamp
and all the displays disappear.
10
button
Selects desired operation mode.
11
button
Selects a unit number (left) and louver number (right).
UNIT:
Selects an indoor unit when adjusting louver direction
when multiple indoor units are controlled with one
remote control.
LOUVER:
No function

12

button
Adjusts the set point.
Select the desired set point by pushing TEMP.
or TEMP. .
OPTION :
Remote control sensor
Usually the temperature sensor of the indoor unit
senses the temperature. The temperature on the
surrounding of the remote control can also be
sensed.
For details, contact the dealer from which you have
purchased the air conditioner.
183529 10 6 7124 11
23-EN
+001111052101_00Ta.book Page 23 Friday, November 20, 2009 1:13 PM