Toshiba S2T installation instructions

T-PDS Setup: In T-PDS under the Option Menu, select Communications. Set as follows:

Using T-PDS, set the following in special register SW63:	This setting can also be made
	in the ladder logic with a MOV
	instruction.

This completes the T-PDS setup. T-PDS can now be connected to the S2E via Ethernet through the GEN651A Ethernet module.

Note: If an attempt is made to assign an IP address in T-PDS before the computer’s Ethernet card is assigned a corresponding IP address, then T-PDS will return a Win Socket error.

Page 4