4.30 Fluorescent Lamp 4 Replacement Procedures
Assembling the 14.1-inch XGA TOSHIBA Fluorescent Lamp
To assembling the 14.1-inch XGA TOSHIBA fluorescent lamp, follow the steps below and
refer to figures 4-143 to 4-149.
Putting the double-sided tapes on the bezel
1. Attach the double-sided tape to the reverse side of the bezel, as shown in Figure 4-
143.
—¼–ʃe[ ƒv“\‚è‹KŠi
—¼–ʃe[ƒvF ‚S‚T‚X‚Vi Z —F‚R‚lj
iƒe[ ƒv’·‚³j
}0.5
285
ƒe[ƒv“¯ ud ‚È‚ç‚È‚¢‚±‚Æ
‰z‚¦‚È‚¢‚±‚Æ
ƒe[ƒv’[‚ªƒxƒ[ƒ‹ŠJŒû ”‚æ‚è
‰z‚¦‚È‚¢‚±‚Æ
ƒe[ƒv’[‚ªƒxƒ[ƒ‹ŠJŒû ”‚æ‚è
ƒe[ƒv‚Ì‚Í‚Ýo ‚µ–³‚«‚±‚Æ
ƒxƒ[ƒ‹ŠJŒû ”‚æ‚è
iƒe[ƒv j
0
+0.2
1
Œö·‚O` ‚OD‚T‚͈̔͂œ\ t‚·‚邱‚Æ
ƒxƒ[ƒ‹ŠJŒû ”‚æ‚è
ƒxƒ[ƒ‹— –Ê
R
everse s
id
e o
f
t
h
e
b
eze
l
Requirements for attaching
double–sided tape
The end of tape must
not go beyond the
opening of bezel.
Tape must not go beyond
the opening of the bezel.
Double-sided tape
(4597, Sumitomo 3M)
Attach tape within tolerances from 0.0 to 0.5
from the opening of the bezel.
(tape
wi
dt
h
)
(tape length)
Tapes must not be overlapped.
The end of tape must not go
beyond the opening of bezel.
Figure 4-143 Attaching double-sided tape to the bezel's reverse side
Satellite A20 Maintenance Manual (960-444) 4-185