Toshiba Toshiba Network Camera quick start Waterproof Connector

Waterproof Connector

Sealing Nut (A)

Housing (B)

Seals (C)

Seal (D)

Screw Nut (E)

Hex Nut (F)

Assembling Steps

1.Disassemble the components of the waterproof connector into parts (A) ~ (E) as shown above. And Hex Nut is including in the accessory separately.

2.Place the screw nut (E) as shown.

3.Feed the power cables through the waterproof connector (F --> E --> D --> B --> A) as the illustration shows. Then connect the power cables to the power source. Note: There are 8 holes on the seal (D), and the widest holes with a crack on the side are specific for power cables.

4.If you have external devices such as sensors and alarms, feed the cables through

Connecting RJ45 Ethernet Cable

RJ45 Cable Dimension (unit: mm)

Recommended cable gauge: 24AWG (0.51 mm)

Assembling Steps:

1

Gasket

2

(A)

(B)

(D)

(E)

(F)

the waterproof connector (F --> E --> D --> B --> A) as previously described. Refer to the pin definition to connect them to the general I/O terminal block. Note: The recommended cable gauge is 2.0 ~ 2.8 mm.

5.Push the seal (D) into the housing (B).

6.Insert the seals (C) into unused holes on the seal (D) to avoid moisture.

7.Secure the sealing nut (A) tightly and hex nut

(F)from the bottom of the camera.

1.Drill a hole on the supplied gasket and insert an Ethernet cable through the opening.

2.Strip part of the sheath from the Eth- ernet cable.

14