TD-VG3631 300Mbps Wireless N VoIP ADSL2+ Modem Router User Guide
52
You can specify the value between 1-255 Beacon Intervals. The default value is 1, which
indicates the DTIM Interval is the same as Beacon Interval.
¾ Enable Short GI: This function is recommended for it will increase the data capacity by
reducing the guard interval time.
¾ Enabled Client isolation: This function can isolate wireless stations on your network from
each other. Wireless devices will be able to communicate with the Modem Router but not
with each other. To use this function, check this box. Client isolation is disabled by default.
¾ Enable WMM: WMM function can guarantee the packets with high-priority messages being
transmitted preferentially. It is strongly recommended.
) Note:
If you are not familiar with the setting items in this page, it's strongly recommended to keep the
provided default values; otherwise it may result in lower wireless network performance.
4.6.6 Wireless Status
Choose menu “Wireless”Æ”Wireless Status”, you can see the MAC Address, Current Status,
Received Packets and Sent Packets for each connected wireless station.
Figure 4-34
¾ MAC Address: The connected wireless station's MAC address
¾ Current Status: The connected wireless station's running status, one of STA-AUTH/
STA-ASSOC/ STA-JOINED/ WPA/ WPA-PSK/ WPA2/ WPA2-PSK/ AP-UP/ AP-DOWN/
Disconnected
¾ Received Packets: Packets received by the station
¾ Sent Packets: Packets sent by the station
You cannot change any of the values on this page. To update this page and to show the current
connected wireless stations, click on the Refresh button.
4.7 Voice Choose “Voice”, there are eight submenus under the main menu. Click any of them, and you will
be able to configure the corresponding function. The detailed explanations for each submenu are
provided below.