TP-Link manual The Back Panel, System Requirements, TL-WR340G/TL-WR340GD

TL-WR340G/TL-WR340GD

54Mbps Wireless Router User Guide

2.2The Back Panel

Figure 2-2

The following parts are located on the rear panel (View from left to right).

¾POWER: The Power plug is where you will connect the power adapter.

¾1, 2, 3, 4 (LAN): Through these ports, you can connect the Router to your PCs and the other Ethernet network devices.

¾WAN: RJ45 WAN port for connecting the router to a cable/DSL Modem, or Ethernet.

¾RESET: There are two ways to reset the Router's factory defaults. With the router powered on, use a pin to press and hold the Reset button until the SYS LED becomes quick-flash from slow-flash (about 5 seconds), and then release the button and wait the router to reboot to its factory default settings, or restore the default setting from “System Tools - Factory Defaults” of the Router's Web-based Utility.

¾Antenna: Used for wireless operation and data transmit.

2.3System Requirements

¾Broadband Internet Access Service (DSL/Cable/Ethernet)

¾One DSL/Cable Modem that has an RJ45 connector (you do not need it if you connect the router to the Ethernet)

5