Installation
Installation Procedure
Plenum Installation
Reference Figure
1.Before installing the plenum, ensure the evaporator fan is in the discharge position. If not, see the fan discharge conversion procedure on page 16.
2.Apply the soft gasket material provided completely around the top of the unit frame as shown in the detail drawing.
3.Tighten the screws provided as shown. Use screws on the rear, right, and left sides through the pilot holes on the plenum panels.
4.After the plenum is installed, adjust the motor pulley for the correct airflow and discharge grille for the correct airflow direction.
A
Figure I-IP-4. Plenum installation
SOFT GASKET (PROVIDED)
1/4" X 1" (PROVIDED)
| 2.0 | 31.5 |
|
| |
14.72 | 12.73 | 14.96 |
1.57 |
|
|
18 |