Enroll Thermostat into existing Schlage LiNKTM System
20 Prepare the Schlage Bridge for enrollment.
•If you are using a controller that is not a Schlage Bridge, consult the instructions that came with the controller to find out how to enroll a new device.
a.Unplug Ethernet and power cables from Schlage Bridge.
b.Install a quality 9 volt battery.
c.Verify that blue light is blinking. If blue light is solid, battery is dead. Replace with new 9 volt battery, if needed.
d.Take the Schlage Bridge to the location where the thermostat is mounted.
Blue light
Battery
21 Enroll the thermostat into the Schlage Bridge.
a.Hold the Schlage Bridge within 6 feet (1.8 meters) of the thermostat
throughout steps “b” through “f”.
• Important Note: After you begin the enrollment process, you have 30 seconds to complete the remainder of the steps. Study the steps below before beginning.
b. Press and release the plus (+) button on the Schlage Bridge. c. Press the MENU button on the thermostat.
d. Scroll down to Z Wave Install, and press the Select button. e. Press the Yes button to enroll the thermostat.
f. Observe the lights on the Schlage Bridge. The orange light will blink while enrollment is taking place. Enrollment is complete when the orange light becomes solid.
11:15 PM |
| Menu Selection |
|
|
| User Settings |
|
| |
78 | 78 C |
|
| |
| 68 H | Usage Graph |
|
|
|
| ESM Setpoints |
|
|
|
| ZWave Install |
|
|
MENU MODE FAN | RUN | Done | Select | Scroll |
|
| down | ||
|
|
|
|
|
| Select button | |
|
| ||
MENU button | |||
| |||
22 Verify enrollment of the thermostat. |
|
|
| |
a. Scroll down to Thermostat Info, and press the Select button. | Thermostat Info |
| ||
b. Look at the number listed after ZNID. | TZEMT400BB32 | Ver: 01.00.10 | ZNID | |
ZVER:02.00.0 | ZNID: 013 | |||
• If the number listed there is anything other than “000”, the | ||||
ZHID: 01.07.37.a7 |
|
| ||
thermostat has been successfully enrolled. | System Type: | Standard |
| |
Fan Type: | Gas |
| ||
• If the number listed there is “000”, the thermostat has NOT |
| |||
Done |
|
| ||
been successfully enrolled. In this case, repeat step 21 and |
|
| ||
|
|
| ||
verify again. |
|
|
| |
c. Press Done button 2 times when finished. |
|
|
| |
11