Transition Networks SGETF1013-100 SGETF10xx IN THE NETWORK, Installation, Set 4-Position Switch

SGETF10xx IN THE NETWORK

Install two SGETF10xx series media converters in series to extend, over fiber, the distance between two 1000BASE-TX devices.

Use one SGETF10xx media converter to connect a 1000BASE-TX terminal device and a 1000BASE-SX/LX hub, switch, or router.

NOTE: A TRANSITION Networks stand-alone media converter can be installed in series with a TRANSITION Networks chassis media converter that has a related model number, such as an SGETF10xx with a CGETF10xx.

INSTALLATION

Set 4-Position Switch

Use small flatblade screwdriver or similar device to set recessed switches. Refer to drawing for four-position switch locations.

Full/Half-Duplex Advertisement (UP=Enabled) Allows full-duplex mode.

(DOWN) Allows half-duplex mode.	Full/Half-Duplex Advertisement UP=ON
Pause Advertisement (UP=Enabled)
	Pause Advertisement UP=ON
Allows auto-negotiation pause. (DOWN)	LPT UP=ON
Allows NO auto-negotiation pause.
	Not Used

NOTE: If the Pause feature is present on

all network devices attached to the media converter(s), enable Pause on the media

converter(s). Otherwise, disable Pause on the media converter(s).

LPT (UP=Enabled) Allows a fault EITHER on the copper OR on the fiber side of the media coverter to stop signal and data transmission on the other side. (DOWN) Disables LPT.

TECHNICAL SPECIFICATIONS

Standards	IEEE 802.3ab, IEEE 802.3 1998
Data Rate	1000 Mb/s
Dimensions	3.4" x 0.86" x 5.0" (86mm x 22mm x 127mm)
Weight	8 oz (approximate)
Delay	300 nsec
Power Consumption	6.5 Watts

Power Supply Requirements Replace power supply with only the equivalent input rating (see below) and output rating (unregulated 9-24VDC, 5.5W).

TN PN	Requirement	Location
12 V, 1.5 A
3507	240 volts, 50 hertz	United Kingdom
3342	230 volts, 50 hertz	Europe
3340	120 volts, 60 hertz	USA/Canada/Mexico
3346	100 volts, 50-60 hertz	Japan
3511	240 volts, 50 hertz	Australia
3537	IEC320 (with power cord: 3522)	South Africa
9 V, 1 A
25039	IEC320, 90-250VAC input	NOTE: Requires
		appropriate IEC320
		power cord for location
25040	120 volts, 60 hertz	USA/Canada/Mexico
Environment	Typical Operating Temperature*:	0° to 50°C (32° to 122°F )
	Storage Temperature:	-20° to 85°C (-4° to 185°F)
	Humidity	10-90%, non condensing
	Altitude	0-10,000 feet
Warranty	Lifetime

	DECLARATION OF CONFORMITY
Name of Mfg:	Transition Networks
	6475 City West Parkway, Minneapolis MN 55344 USA
Model:	SGETF10xx-100 Series Media Converters
Part Number(s):	SGETF1013-100, SGETF1014-100, SGETF1015-100,
	SGETF1017-100
Regulation:	EMC Directive 89/336/EEC

Purpose: To declare that the SGETF10xx-100to which this declaration refers is in conformity with the following standards.

EMC-CISPR 22: 1985 Class A&B; EN 55022: 1988 Class A&B; EN 50082-1:1992; EN 60950 A4:1997; IEC 801.2, IEC 801.3, and IEC 801.4; IEC 950

I, the undersigned, hereby declare that the equipment specified above conforms to the above Directive(s) and Standard(s).

	_ January 6, 2001_____
Stephen Anderson, Vice-President of Engineering	Date