Transition Networks SIBTF10XX-1XX-MR Technical Specifications, 220-240VAC, 50/60Hz installation

SIBTF10xx-1xx-Mx

Technical Specifications

For use with Transition Networks Model SIBTF10xx-1xx-Mx or equivalent.

Standards:	IEEE 802.3™ 2000, IEEE 802.3x™
Data Rate:	10 Mb/s, 100 Mb/s (copper), 100 Mb/s (fiber)
Dimensions:	Models 130- & 140-Mx
	(W x H x D) 4.125" x 6" x 5" (104.77 x 152.4 x 127 mm)
Dimensions:	Model 110-Mx
	(W x H x D) 3.375" x 6" x 5" (85.73x 152.4 x 127 mm)
Weight:	3.2 lb. (1.5 kg) approximately
Input Voltage:	48–170VDC +/-15%
	90–125VAC +/-15%, 50/60 Hz
Power:	15 W (maximum)
	Aux input standby power, 200 mW typically
Fuse:	2.5 A/250 VDC
Alarm Relay:	Three-position screw terminal block for the dry contact relay
	0.5 A @ 125 VAC / 2.0 A @ 30 VDC (maximum)
	switching capacity: 60 W (maximum)
Packet Size:	Memory: 64K Bytes
	Unicast MAC addresses: 1000
	Maximum packet size: 1536 Bytes
MTBF*:	51,115 MIL-HDBK-217F Hours
	153,038 Bellcore Hours
Environment	-40 to 75°C (-40 to 167°F)
Operating Temp:
Storage Temp:	-40 to 85°C (-40 to 185°F)
Humidity:	5 to 95%, non-condensing
Altitude:	3000 m (10,000 ft.)
Warranty:	Lifetime

The industrial switch is designed for installation in restricted access locations. Installing the industrial switch into other equipment or facility control rooms must comply with the fire-enclosure requirements of IEC60950/EN60950/UL60950, along with other local, national fire and safety codes.

IMPORTANT: Copper based media ports: e.g., Twisted Pair (TP) Ethernet, USB, RS232, RS422, RS485, DS1, DS3, Video Coax, etc. are intended for connecting to intra-building (inside plant) link segments, not subject to lightening transients or power faults. Copper based media ports: e.g., Twisted Pair (TP) Ethernet, USB, RS232, RS422, RS485, DS1, DS3, Video Coax, etc. are NOT for connecting to inter- building (outside plant) link segments subject to lightening transients or power faults.

*MTBF is estimated using the predictability method. This method is based on MIL- 217F at 25°C ambient temperature, typical enclosure heat rise of 10°C, and nominal operating conditions and parameters. Installation and configuration specific MTBF estimates are available upon request. Contact Technical Support.

Technical Specification -- continued

220–240VAC, 50/60Hz installation

CAUTION: If the main power source is 220-240VAC @50/60Hz, use a 2:1, 50VA or greater step-down transformer between the main power source and the industrial switch. Failure to observe this caution could result in a damaged switch.

EMC Type Tests (all test were performed using unshielded cables)

Standard	Description	Compliance Level	Remarks
EN55022/FCC Part15	ITE Emissions	Class A	Conducted and radiated
EN55024/EN61000-6-2:	ITE Emissions
IEC61000-4-2		Level 2	ESD contact discharge
IEC61000-4-3		Level 4	Radiated fields
IEC61000-4-4		Level 3	Fast transients - power port
			2 meter cable AC
			1 meter cable DC
		Level 2	Fast transient – Ethernet port
			3 meter cable length
IEC6100-4-5		Level 3 CM	Surge – power port
		Level 2 DM	2 meter cable AC
		Level 1 DC	1 meter cable DC
		Level 2	Surge – relay port
			1 meter cable length
		Level 2	Surge – Ethernet port
			3 meter cable length
IEC61000-4-5		EN61000-6-2 Level 3	Conducted – power port
		EN55024 Level 2	2 meter cable AC,
			1 meter cable DC
		EN61000-6-2 Level 3	Conducted – relay port
		EN55024 Level 2	1 meter cable length
		EN61000-6-2 Level 3	Conducted – PE Studs
		EN55024 Level 2	2 meter cable length
		EN61000-6-2 Level 3	Conducted – Ethernet port
		EN55024 Level 2	10 meter cable length
IEC61000-4-8		Level 1	Power freq. mag. field
IEC61000-4-11		N/A	VoltageDIPs and variations
IEEE1613, Power Substation Testing
IEEE1613, Clause 6.2		Not rated	Dielectric power freq.
IEEE1613, Clause 6.3		Compliant	Impulse voltage all ports
IEEE1613, Clause 7.3.1		Class 2 transverse and	Surge oscillatory waveform
		common Mode	–power AC
		Class 2 transverse and	Surge oscillatory waveform
		common Mode	–power DC
		Class 2 common mode	Surge oscillatory waveform
			–relay port
		Class 2 common mode	Surge oscillatory waveform
			–Ethernet 10 Mbps
		Class 1 common mode	Surge oscillatory waveform
			– Ethernet 100 Mbps

22 24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600 techsupport@transition.com -- Click the “Transition Now” link for a live Web chat. 23