Transition Networks SMACF10XX quick start Install SMACF10xx in Network, Quick Start Guide

SMACF10xx Management Aggregation Converter

QUICK START GUIDE

Install SMACF10xx in Network

1. Unpack and Install SMACF10xx Units Place SMACF10xx units on table or other flat, stable surface in well-ventilated area.

Corporate		Technical
Management	Accounting
		Publications
Remotely
Managed
Converters
Manufacturing		Sales & Marketing
& Logistics

MM or SM Fiber

2.Power On SMACF10xx Units Install power adapter cord at back of each SMACF10xx unit. Connect power adapter plug to AC power. Verify power by observing illuminated LEDs.

3.	Connect SMACF10xx Units to Ethernet™ Network Locate path
	to Ethernet™ segment. Use Category 5 twisted-pair cable and
	appropriate fiber cable to connect SMACF10xx Management Unit

SNMP Management of all Remote Reporting Units

PointSystem

Modular Chassis

Copper Switch

through any port (optionally through a hub or switch) to the Ethernet™ segment. Connect AT LEAST ONE port on EACH installed SMACF10xx Reporting Unit (optionally through a hub or switch) to the same Ethernet™ segment.

Main Management Unit		Reporting Unit
	MM or SM Fiber	CAT 5
CAT 5		CAT 5
	In-Band Management
LAN Switch	VLAN Segmentation
	10 or 100 Mb/s Speed Selection
CAT 5
	SNMP Management
	of Both Main Management
	and Reporting Units

Network managed by SMACF10xx Management Unit.

Network managed by CPSMM-xxx PointSystem™ Management

Module connected to switch on same segment as Reporting Units.

Configure Main Management Unit or Management Module Installed in Chassis

NOTE: The SMAC10xx Management Unit contains both a Management Unit and a Reporting Unit. Each must be configured separately.

4.Connect Management Unit or Management Module to Terminal Locate null modem DB-9 serial port cable with female DB-9 connector. Attach DB-9 serial port female cable connector to DB-9 serial port male connector on SMACF10xx Management Unit OR on CPSMM-xxxPointSystem™ Management Module installed in Media Conversion Center. Attach other end of DB-9 serial port cable to ASCII terminal or terminal emulator.

5.Verify Terminal Settings Default terminal settings are 9600 Baud/ 8 data bits/ 1 stop bit/ no parity. If necessary, use methods appropriate to terminal to modify settings.

6.Bring up Management Unit Interface at Terminal (SMACF10xx Management Unit ONLY) First set switch at back of SMACF10xx Management Unit to UP position. (SMACF10xx Management Unit and CPSMM-xxx PointSystem™ Management Module) Press <enter> at terminal keyboard to bring up command-line prompt.

7.Enter superuser Mode At command-line prompt, type and enter the su command, using the case-sensitiveTransition Networks default password private.

CPSMM100> SU=private

2