Project | Quantity | Item # |
Model Specified: |
| CSI Section 11400 |
|
|
|
Specifications
Construction, Hardware and Insulation
Cabinet exterior, including front, one piece sides, louver assembly and doors are constructed of heavy gauge stainless steel. Cabinet interior and door liners are constructed of stainless steel. Exterior cabinet top and bottom are constructed of heavy gauge aluminized steel. The interior floor is constructed of stainless steel and insulated with 3⁄4" of resilient cork. A readily attachable stainless steel ramp is provided.
Refrigeration System
Atop mounted,
Controller
Doors are equipped with
Easily removable for cleaning, vinyl magnetic door gasket assures tight door seal. Anti condensate heaters are located behind each door opening.
Cabinet and door contains high density,
DIMENSIONAL DATA | RRI264LPUT | RRI364LPUT |
Net capacity cu. ft. | 160.4 (4544 cu l) | 243.0 (6884 cu l) |
Length - overall in. | 68 (172.7 cm) | 1001⁄2 (255.3 cm) |
Depth - overall in. | 711⁄8 (180.6 cm) | 711⁄8 (180.6 cm) |
Depth - over body in. | 64 (162.6 cm) | 64 (162.6 cm) |
|
|
|
Depth - with door open | 1261⁄2 (321.3 cm) | 1261⁄2 (321.3 cm) |
90 degrees in. |
|
|
Clear door width in. | 271⁄16 (68.8 cm) | 271⁄16 (68.8 cm) |
Clear door height in. | 665⁄16 (168.4 cm) | 663⁄8 (168.6 cm) |
Height - overall in. | 831⁄4 (211.5 cm) | 831⁄4 (211.5 cm) |
Rack Capacity | 4 | 6 |
Net Wt. lbs. | 775 (352 kg) | 1050 (476 kg) |
ELECTRICAL DATA |
|
|
Voltage | ||
Feed wires with Ground | 4 | 4 |
|
|
|
Full load amperes | 15.0 | 15.6 |
|
|
|
Wattage1 | 2157 | 2447 |
REFRIGERATION DATA |
|
|
Refrigerant | ||
BTU/HR H.P.2 | 8400 (2 x 1⁄2 HP) | 10240 (2 x 3⁄4 HP) |
NOTES
NOTE: Figures in parentheses reflect metric equivalents.
1= Based on a 90 degree F ambient and 20 degree F evaporator.
2= Wattage is determined by listed amps X listed volts X an average run time of 70% for refrigerators and 80% for freezers.
3= For approximate remote weights deduct 40 lbs. from respective net or gross weight. For other information on remote models, please refer to spec sheet
4= Shipped in two cartons for assembly at job site. For total shipping weight, double figure shown.
The easy to use water resistant
Interior
Readily removable,
Warranties
Both a one year parts and labor warranty and a five year compressor warranty (self- contained models only) are provided standard. An optional 2nd year extended parts and labor warranty is also available. In addition the
NOTE: When ordering please specify: Voltage, Hinging, Door Size, Options and
any additional warranties. For fast order entry: Fax 1 (800)
Continued product development may necessitate specification changes without notice. Part No. TR35809 (revised 1/07)
REQUIRED CLEARANCES
In order to assure optimum performance, the condensing unit MUST have an adequate supply of air for cooling purposes. Therefore, the operating location must either have a minimum of 12” clearance overhead of the condensing unit or allow for unrestricted air flow at the back of the unit. Clearance of at least 12” above is required in order to perform certain maintenance tasks.
SECTION | TRAULSEN |
|
4401 BLUE MOUND RD. | FT. WORTH, TX 76106 | |
PHONE 1 (800) |
Website: www.traulsen.com