B. REMOTE TEST
1.Connect one end of the test cable to the MASTER unit marked TX .
2.Set the power switch to ON and set the tester to
Auto scan. The TX LED will begin to scroll in sequence (1,2,3,..., shield and repeat), to indicate the pins being tested. Use a patch cord (included) if the test cable terminates into a wall jack or patch panel.
3. At the remote location, connect the other end of the test cable to the Remote terminator. The LED on the Remote terminator will light (or not) in relation to the Master tester unit to indicate status.
4.To test BNC, USB or other cable configurations, please use the appropriate adapters and follow the above procedure.
C. SENDING TONE TO IDENTIFY CABLES
Using Network cable tester s tone generator along with Net Probe or any other tone probe, enables one to quickly isolate and locate a hidden cable or a break (open) in the middle of a
5
