Troubleshooting
Q1: I specified the IP address http://192.168.1.100 in my internet browser's address bar, but error message says "The page cannot be displayed". How can I get into the
A1: Please check your hardware and TCP/IP settings again by following the instructions sections 1~3, make sure the Power, WAN, WLAN on the Access Point's front panel are on and the TCP/IP configurations are correct. then try accessing http://192.168.1.100 again.
Q2: If my network's IP is different than the Access Point's range, what
should I do?
A2: You should still configure the access point first. After all the settings are applied, go to the Access Point's configuration page, click on TCP/IP settings and change an IP address for the Access Point to match your network's IP.
Q3. After I successfully configured the Access Point to meet my network
settings, I cannot connecting to my network using wireless computers.
A3: If you have a DHCP server in your network, you need to go into TCP/IP settings again and
Windows 98/ME and "Obtain an IP Address automatically" for Windows 2000/XP to allow the PC to regain an IP address from your DHCP server.
Q4. All the settings are set correct, but I still can't use the Access Point,
what should I do?
A4: You can find additional information in the User's Guide. If you still have Problems, contact our Technical Support by email or phone.
Contact Technical Support
Telephone:
Fax:+1-310-626-6267
Website:www.TRENDNET.com
Technical Support Hours
7:00AM ~ 6:00PM, Monday through Friday Pacific Standard Time (except holidays)
14
