TRENDnet TEW-430APB manual Install Hardware, Verify Hardware Installation, 2English

2.Install Hardware

1.Locate an optimum location for the Access Point. The best place for the Access Point is usually at the center of your wireless network.

2.Connect the RJ-45 network cable to the Access Point, then connect the other end of the network cable to a Switch or Hub. The Access Point is now connected to your 10/100mbps network.

3.Connect the power adapter to the Access Point. Make sure you use the power adapter supplied with the Access Point; using a different power adapter may damage the unit.

POWER

TEW-430APB

3

2

NOTE: If you are using a wired computer to configure the Access Point,please connect this computer to the same Switch or Hub the TEW-430APB is connected to.

LAN

POWER WLAN

Verify Hardware Installation

Check to make sure the following Access Point front panel lights are on: Power, LAN, WLAN.

2English