© Copyright 2013 TRENDnet. All Rights Reserved.
34
4. Review the Inbound Class Setting section.
• BW Max Inbound: Enter the maximum download speed of your ISP (Internet
Service Provider).
• Highest/High/Medium/Low/Lowest: Enter the download speeds you would like
to apply on each state of download speeds. This setting is similar to setting the
priority speeds of each class
5. Review the Outbound Class Setting section. These fields would automatically
populate when Inbound Class is configured, but setting allows you make any fine
adjustments. Click Apply to save settings.
• BW Max Inbound: Enter the maximum upload speed of your ISP (In ternet Service
Provider).
• Highest/High/Medium/Low/Lowest: Enter the upload speeds you would like to
apply on each state of download speeds. This setting is simil ar to setting the
priority speeds of each class
6. Review the QoS Rule settings.
• IP/MAC Address Filter: Select from the pull down menu the IP address or MAC
you would like to apply and enter the IP address of MAC address.
• Protocol Filter: Select the protocol you would like to apply on the QoS Rule.
• Port Filter: Select the port from the pull down menu you would like to assign on
the QoS rule and enter the port.
• Class Assigned: Select from the pull down menu the class you applied on the
previous section you would like to assign the QoS rule.
• Description: Enter the QoS description that best describes the rule.
7. Click Add Rule to save the settings.
Advanced > ALG
You may want to setup your router to allow computers to use certain protocols or
services on your network. Application Level Gateway or ALG allows you to simply enable
or disables these services.
Note: Default all services are enabled.
1. Log into your router management page (see “ Access your router management page”
on page 26).