INSTALLATION
This cooker must be installed in accordance with the IEE Wiring Regulations (Current Edition). Detailed recommendations are contained in the following British Standards Codes Of Practice:
B.S. 6172/ B.S. 5440, Par.2 and B.S. 6891 Current Editions.
The appliance must be installed in accordance with
"Y " specification
Please ensure that when the appliance is installed it is easily accessible for the engineer in the event of a breakdown.
Before your appliance is connected to the mains electricity supply, check to ensure that the voltage and the frequency shown on the rating plate correspond with your supply voltage.
This appliance must be earthed.
LOCATION
The appliance must not be installed in a
shower room. It is essential that the appliance is |
|
positioned as in the enclosed figure i.e. shelves, wall |
|
cabinets and cooker hoods must be fitted a minimum |
|
of 690mm directly above the top of hotplate and |
|
400mm above the hotplate when fitted in line with the | 400 |
outside of the appliance. If the units are intended to |
be fitted adjacent to the appliance but less than 400mm above the hotplate, then a minimum space of 100mm must be maintained between the sides of the unit and the appliance (see fig).
If fitted next to or between two base units a minimum space of 1mm must be left between each unit and the sides of the appliance. The levelling feet fitted to the appliance will achieve a nominal height to hotplate of 900mm+10mm.
The appliance must be installed in accordance with EN
The appliance must be set on a heatproof floor. The adjustable feet must not be removed.
Levelling
The appliance is provided with adjustable small feet placed in the back and front corners of the base.
By adjusting the small feet it is possible to change the height of the appliance so as to ensure a better levelling with other surfaces and an even distribution of the liquids contained in pots and pans.
690
max 400
min 600
min 570
690 |
100 |
less than |
400 |
6
