FITTING INTO THE CABINET
IMPORTANT: Ensure that the oven is switched off at the wall before any further work is carried out.
•Using a tape measure establish the internal width of the cabinet. Refer to page 29 if greater than 565mm.
•Position the appliance in front of the cabinet. See Fig. 8.
•Take out all oven furniture before installation to reduce the weight you need to lift. The oven door should be taped up to keep it closed whilst lifting.
•To place the appliance into the cabinetry follow the procedure below:
•N.B. Two people will be required to carry out the lifting procedure.
Warning: Do not attempt to lift this appliance by the handle(s).
a)Each person should squat either side of the appliance.
b)Tilt the appliance so that your hands can support the underside of the appliance.
c)Keeping your back straight, raise the appliance to the correct height by straightening at the knees.
d)Rest the rear underside of the appliance on the cabinet floor while your hands support the front.
e)The appliance can be pushed fully into the cabinet. Take care to avoid fouling the mains lead.
f)Ensure the appliance is central and level.
g)Do not remove spacers fitted behind fixing holes.
h)When the appliance is fully housed screw the stability screws (supplied with the appliance) into the side of the cabinet taking care not to distort the side trims (See Fig 9). It is advisable to turn each screw alternatively to avoid damaging the trims.
i)Switch on the appliance then refer to the operating instructions.
32
Fig. 8
Fixing points for stability screws
Fig. 9
