Models in stainless steel or aluminium:
We recommend to clean the oven door using only a wet sponge and dry it up after cleaning with a soft cloth. Never use steel wool, acids or abrasive products as they can damage the oven surface.
Clean the oven control panel following the same precautions.
DO NOT clean the oven door while the glass panels are warm. If this precaution is not observed the glass panel may shatter. If the door glass panel becomes chipped or has deep scratches, the glass will be weakened and must be replaced to prevent the possibility of the panel shattering. Contact your local Service Force Centre who will be pleased to advise further.
Oven Cavity
The enamelled oven cavity is best cleaned whilst the oven is still warm.
Wipe the oven over with a soft cloth soaked in warm soapy water after each use. From time to time it will be necessary to do a more thorough cleaning, using a proprietary oven cleaner.
Oven Shelves and Shelf Supports
To clean the oven shelves, soak in warm soapy water and remove stubborn marks with a well wetted soap impregnated pad. Rinse well and dry with a soft cloth. The shelf supports can be removed for easy cleaning.
!Proceed as follows:
1) remove the front screw while keeping the shelf support in position with the other hand (see diagram 4);
2) disengage the rear hook and take off the shelf support (see diagram 5);
3) once the cleaning is carried out, refit the shelf supports following the procedure in reverse.
Please, ensure the retaining nuts are secure when refitting the shelf support.
4
5
Replacing the Oven Light
Disconnect the appliance.
If the oven bulb needs replacing, it must comply with the following specifications:
-Electric power: 15 W / 25 W;
-Electric rate: 230 V (50 Hz);
-Resistant to temperatures of 300 °C;
-Connection type: E14.
These bulbs are available from your local Service Force Centre.
!To replace the faulty bulb:
1. Ensure the oven is disconnected from the electrical supply.
2. Turn the glass cover anticlockwise.
3. Remove the faulty bulb and replace with the new one.
4. Refit the glass cover.
5. Reconnect to the electrical supply.
13 |
