Trion Supreme Series warranty Installation, Typical Mounting Positions, Application, Transitions

Installation

TYPICAL MOUNTING POSITIONS

(Air cleaner shown shaded in illustrations)

WARNING

Before making changes to a HVAC system that may affect the ventilation of fuel-burning appliances, contact your heating contractor.

Transitions

Transitions

Basement Furnace	Counterflow	Space Saver
(Lowboy) -Mounted	Furnace–	Furnace
horizontally in return	Mounted	(Highboy)- Side
plenum– just above	horizontally in	installation.
	return duct–
the furnace.		Mounted
	just above the
		vertically, where
	furnace.
		return air enters
		side inlet of
		furnace.

		Before	After
Horizontal Furnace–
	Offset Installation– If there is less
Mounted vertically in return	than 7-in. for mounting the air
duct as close to the furnace	cleaner between the duct and the
as possible.	furnace, move the return air drop.

Installation

Application

This air cleaner is used in forced air heating, cooling, and ventilating systems. The air cleaner should be installed in the system such that all the system air is circulated through the air cleaner. Maximum performance is obtained with the system blower set for continuous operation.

Installation Requirements

The best location for the air cleaner is in the return air duct next to the blower compartment. In this location, the blower motor and cooling coils will be kept clean. Do not install the air cleaner in the discharge air duct. Before installing the air cleaner, consider the application. If a transition between the ductwork and air cleaner is required, refer to section entitled Transitions, below. The unit must be readily accessible for periodic inspection and replacement of the filter cartridge to maintain maximum efficiency and trouble-free operation. A clean coil will reduce utility costs by maintaining the coil’s efficiency. Failure to replace filter cartridge can cause damage to the cooling system. Allow a minimum of 26” clearance in front of the access panel for filter cartridge replacement.

Transitions

If the air duct does not fit the air cleaner cabinet opening, gradual transitions are recommended to reduce air turbulence through the air cleaner and maximize efficiency. Not more than 20° (about 4” per running foot) of expansion should be used on each side of the transition fitting.

Maximum 4" drop per linear foot

Air Flow

	CleanerAir
Air Flow		opening	Furnace opening
				Furnace

Air Cleaner

Transition section

4 5