Tripp Lite 2POSTRMKITWM Rack Mounting continued, Tower Mounting, Post Mounting, All UPS Models

Rack Mounting continued

2-Post Mounting

Mount 1U UPS models in 2-post racks with included hardware following the procedure below.

If you mount 2U UPS models in 2-post racks, they require the addition of a Tripp Lite 2-Post Rackmount Installation Kit (model: 2POSTRMKITWM, sold separately). See Installation Kit owner’s manual for installation procedure for 2U UPS models.

1Attach mounting ears A to the front mounting holes of your equipment B using the screws provided C . The ears should face backward.

B

C

A

1

2Using an assistant if necessary, lift your equipment and slide it onto the mounting shelves. Attach your equipment to the rack by passing the screws, nuts and washers provided D through its mounting ears and into the rack rails.

D

2

Tower Mounting

Mount all UPS models in an upright, tower position using included hardware. The user must deter- mine the fitness of hardware and procedures before mounting.

All UPS Models

Stand your UPS on its side with the LED/Control panel at the top. Attach one rack mounting ear A to each side of the UPS using included screws B . Attach the rack mounting ears to the floor with user-supplied hardware.

B

A

2U UPS Models Only

Rotate the LED/Control panel to view it easier while the UPS is tower mounted. Insert a small screwdriver, or other tool, in the slots on either side of the panel. Pop the panel out; rotate it; and pop the panel back in place.

4