Tripp Lite APS1250F owner manual Specifications, System Overview, Output, Input, Battery

for equipment compatible with a 1/2 cycle transfer time

1250 watts continuous AC output in inverter mode, 1440 watts continuous AC output in AC mode

DoubleBoost inverter output supports momentary startup loads up to 200% of the continuous rating for up to 10 seconds

OverPower inverter output supports longer duration overloads to 150% for 1-60 minutes under ideal battery and temperature conditions (For best results, utilize OverPower usage for as short of a duration as possible, ensure battery bank and cabling is able to provide full nominal DC voltage under load and allow inverter/charger to fully cool before and after OverPower usage)

3 stage, 30 amp battery charger with adjustable settings for wet/gel battery types offers fast, reliable battery recharging

Protected hardwire bolt-down input lugs safely accept heavy gauge input wiring from attached battery bank

Two built-in NEMA 5-15R output receptacles pass 120V line power or inverter output through to connected equipment

Reliability enhanced large-transformer design with secure mounting flanges and protected DC wiring terminals

Moisture-resistant construction enables vehicular or marine operation in high humidity environments

3 position operating mode switch supports "AUTO" mode to enable automatic transfer between DC and AC modes, CHARGE-ONLY to maintain a full battery charge when AC is present without auto transfer and SYSTEM OFF settings

Set of six front panel LEDs display AC/DC operational modes, overload status, DC voltage level, shutdown status and system fault status Set of 4 configuration dip switches support wet/gel battery charging profiles, adjustable 135/145V high voltage auto transfer during overvoltages and selectable 75/85/95/105V AC low voltage auto transfer during brownouts

Resettable 8A charger AC input breaker and resettable 12A AC output breaker and automatic 2 speed cooling fan protect the inverter from load and temperature related failures

Grounding lug properly connects the inverter/charger system to earth ground or vehicle grounding system

Automatic overload and thermal shutoff safely turns off inverter as excessive loads or overheating conditions develop

Front panel remote control connector enables remote off/on switching (requires optional APSRM4 switch accessory). Optional APSRM4 accessory also includes user configurable jacks to support inverter shutoff or startup as a vehicle ignition is engaged.

Specifications

OVERVIEW

Intended Application	Emergency Home Power
SYSTEM OVERVIEW
Voltage compatibility	12V DC / 120V AC
Frequency	60 Hz
compatibility
OUTPUT
Output watts	1250W (continuous) / 2500W (peak)
Output nominal	120V
voltage
Output voltage	LINE POWER (AC): Maintains 120V nominal sine wave output from line power source. INVERTER POWER (AC):
regulation	Maintains PWM sine wave output voltage of 120 V AC (+/-5%).
Output frequency	60 Hz (+/- 0.3 Hz)
regulation
Outlet quantity / type	Hardwire
Overload protection	Includes 8A input breaker dedicated to the charging system and 12A output breaker for AC output loads
Continuous output	1250
capacity (watts)
Peak output capacity	2500
(watts)
INPUT
Input connection type	DC INPUT: Set of 2 DC bolt-down terminals. AC INPUT: NEMA 5-15P input plug
Input cord length	DC INPUT: User supplies cabling. 6 gauge or larger (see manual). AC INPUT: attached 6 ft. AC line cord with plug
Recommended	DC INPUT: Requires 12V DC input source capable of delivering 127A for the required duration (when used at full
Electrical Service	continuous capacity - DC requirements increase during Over-Power and Double-Boost operation). AC INPUT: 15A
	120V AC recommended
Maximum input	DC INPUT: Full continuous load - 127A at 12V DC. AC INPUT: 12 amps at 120VAC with full inverter and charger load
amps / watts	(6.3A max charger-only)

BATTERY