Tripp Lite B114-008 user manual Introduction, Specifications, Installation, Features

200409159 B114-008 Video Splitter Owners Manual.qxd										10/1/2004 1:28 PM Page 1
WARRANTYtoday							chance		User's Manual
REGISTRATION							product!
					for
						a
			.com/warranty
			Tripp			Lite
	-line
		FREE
on
Registerwin	a	.tripplite		Video Splitter (8-Port)
to www
								Model #: B114-008
						NOTE: Follow these installation and operating				Tripp Lite World Headquarters
					procedures to ensure correct performance and
										1111 W. 35th Street,
							to prevent damage to this unit or to its			Chicago, IL 60609 USA
									connected devices.	(773) 869-1234, www.tripplite.com

Introduction:

The Video Splitter is a signal booster and splitter that takes video input from a single source and directs it to multiple video outputs for monitors using analog signals. It extends the distance a signal is sent to about 210 ft.

Features:

•One video input to multiple video outputs

•Transmission distance of up to 210 feet

•Suitable for SVGA, VGA, and Multisync monitors

•Daisy-chain multiple units to increase the number of outputs

•Power-save mode, when the computer is off the power indicator LED's flash

IMPORTANT NOTE: This unit is not designed for CGA, EGA or MONOCHROME type monitors or any monitor using a digital video signal.

Specifications:

Power Consumption	DC 9V, 250mA(max)
Maximum Cable Length	210 feet
Signal Type	VGA, SVGA, Multisync Monitor
Slide Switch	Video Signal Gain Control

Installation:

Stand-Alone Installation:

1.Connect the PC's video output port to the Video Splitter's “Video In” port using an HDDB15 Male/Female Monitor Extension Cable (Tripp Lite # P500-006, P510-006, P510-010 or P510-015).

2.Connect the Video Splitter's “Video Out” ports to the input of your monitors either by using the existing cable on the monitor or by using an HDDB15 Male/Male Monitor Cable (Tripp Lite # P502-006, P512-006 or P512-010).

3.Connect the provided power supply to the Video Splitter and turn on the unit. Your Video Splitter is ready to go.

NOTE: A slide switch located under the Splitter is used to control the Signal Gain (also known as Power Boost). For short distances, set the switch to “Normal” Gain by sliding the switch toward the front panel of the unit. As the distance between Splitter and monitor increases, you may need to increase the unit's Gain by sliding the switch towards the back.

WARNING!

Use ONLY 9V DC in the operation of these devices.

Copyright © 2004 Tripp Lite. All rights reserved. All trademarks are the property of their respective owners.

Technical specifications are subject to change without notice.