
WARRANTY |
| .com/warranty |
| ||||
REGISTRATION: | a | Lite | Owner’s Manual Addendum | ||||
|
|
|
| for | |||
|
| today |
| Tripp |
| ||
| onlineaFREE |
|
| ||||
register | win.tripplite |
|
|
| |||
to |
|
|
|
|
| ||
chance | www | IMPORTANT PRODUCT | |||||
— |
| ||||||
product |
|
| |||||
|
| SAFETY INSTRUCTIONS | |||||
|
|
|
Home Theater-Audio/Video Products
•Read all safety and operating instructions before you operate this product.
•Observe all warnings and instructions marked on your product and its operating instructions.
•Keep this Owner's Manual Addendum for future reference.
1111 W. 35th Street
Chicago, IL 60609 USA
(773)
This product has been designed and engineered to ensure your personal safety. However, improper use of this product could produce electric shock or fire hazards. To avoid defeating the product's
6. Wall or Ceiling Mounting
This product should be mounted on a wall or ceiling only as recommended by the manufacturer.
INSTALLATION
1. Polarization or Grounding
(a)Your product may be fitted with a polarizing
(b)Your product may be fitted with a
2. Power Sources
Operate your product only with the type of power source listed on the marking label. If you are unsure about the type of power supplied to your home, contact your product dealer or the local power company. If your product is designed to use battery power or other power sources, refer to the operating instructions.
3. Overloading
ANTENNA INSTALLATION INSTRUCTIONS
1. Outdoor Antenna Grounding
If this product is to be connected to an outdoor antenna or cable system, the antenna or cable system must be properly grounded to provide some protection against power surges and
2. Lightning
To protect this product during lightning storms or when it is to be left unattended and unused for long periods of time, unplug it and disconnect the antenna or cable system. This will prevent damage due to lightning strikes or power surges.
3. Power Lines
An outside antenna system should never be located near overhead power lines or other electric light or power circuits, nor in an area where they could fall into such power lines or circuits. When installing an outside antenna system, use extreme care to avoid touching power lines or circuits. Such contact could be fatal.
ANTENNA GROUNDING (National Electrical Code, ANSI/NFPA 70)
Do not overload wall outlets, extension cords or integral convenience receptacles, as this could produce an electric shock or fire hazard.
4. Power Cord Protection
Power cords should be routed through areas where they are unlikely to be stepped on or pinched by items placed on or against them, particularly near plugs, receptacles and the point at which they exit from the product.
5. Ventilation
The cabinet of your product has slots and openings to facilitate proper ventilation. To ensure proper operation and to prevent overheating, these openings must not be blocked or covered.
GROUND CLAMP
ELECTRIC SERVICE
EQUIPMENT
POWER SERVICE GROUNDING ELECTRODE SYSTEM (NEC ART 250, PART H)
ANTENNA
LEAD IN WIRE
ANTENNA DISCHARGE UNIT (NEC SECTION
GROUNDING
CONDUCTORS
(NEC SECTION
GROUND CLAMPS
•Do not block openings by placing the product on a bed, sofa, rug or similar surface.
•Do not install the product in a bookcase, rack or similar location unless proper ventilation is provided and all manufacturer's instructions have been followed.
WARRANTY REGISTRATION
Visit www.tripplite.com/warranty today to register the warranty for your new Tripp Lite product. You'll be automatically entered into a drawing for a chance to win a FREE Tripp Lite product!*
* No purchase necessary. Void where prohibited. Some restrictions apply. See website for details.
Copyright ©2005 Tripp Lite. All rights reserved. | 200507227 |
|