Tripp Lite SMP specifications Installation, Connection to the Telephone Line, Specifications

ESPAÑOL: p. 2 FRANÇAIS: p. 3 & 4

1111 W. 35th Street Chicago, IL 60609

(773)869-1234

www.tripplite.com

NOTEBOOK COMPUTER SURGE SUPPRESSORS

SMP, iGuard™

Installation

Plug the surge suppressor into a grounded 3-conductor 120 Volt AC (VAC) outlet. DO NOT use 2-wire extension cords or adapters. When the surge suppressor is plugged in, the RED Indicator Light will illuminate. This light shows AC power is present. Lack of a proper ground connection will eliminate common-mode protection. However, you may plug 2-wire devices into the single surge suppressor outlet. The total full load that can be drawn from the single surge suppressor outlet is 15 amps (1875 watts). DO NOT exceed a total load of 15 amps with equipment plugged into the surge suppressor.

If the surge suppressor is plugged into a vertically-oriented AC outlet or a wall receptacle with four or more outlets, it should be plugged into the lower outlets. If the unit is plugged into a horizontally-oriented wall outlet, it should be plugged into the right hand outlet. This will prevent the unit’s case from blocking any of the other AC outlets.

Connection to the Telephone Line

With the surge suppressor plugged into a properly grounded AC outlet, connection to the telephone line can be accomplished. Refer to the drawing below depicting proper connection of the surge suppressor. A 6-foot standard phone cord with RJ11 plugs is supplied with the surge suppressor. Insert one end of the SUPPLIED phone cord into the RIGHT jack. Connect the other end of the SUPPLIED phone cord into your telephone wall jack. Insert the end of your TELEPHONE’s phone cord into the CENTER jack. Insert the end of your EQUIPMENT’s phone cord (e.g.: laptop computer’s modem) into the LEFT jack. Insert the EQUIPMENT’s AC line cord into the outlet on the front of the surge suppressor. Your equipment is now protected from transient spikes and surges on both the AC and telephone line.

SURGE SUPPRESSOR CONNECTION

EQUIPMENT’s

AC Power Cord

EQUIPMENT’s

Phone Cord

SUPPLIED

Phone Cord

TELEPHONE

Phone Cord

Grounded AC Receptacle

Telephone

Wall Jack

Specifications

Models: SMP, iGuard	Telephone/Data Line Spike Protection:
Rated Input Voltage: 120V AC, 50/60 Hz
	Peak Transient Input Voltage: 6Kv, 10 microseconds
Rated Current and Load Handling: 15 amps maximum (1875 watts)
	Clamping Voltage: 5V±10%
AC Spike Protection:
	Response Time: <1 nanosecond
High Voltage Spike Protection: Handles up to 36,000 amp spikes,	Interface Receptacles: 3 RJ11 modular input/output
450 joules. High voltage spike protection in both normal and	Interconnection Cord: 6 ft. phone cord with male RJ11 plugs
transverse modes.	Controls: Red Indicator Light indicates protection present
Transient Response Time: <1 nanosecond	Dimensions (HxWxD): 3¼” x 2¼” x 1½”
AC Outlet: 1 NEMA 5-15R	Weight: 6 ounces

LIFETIME LIMITED WARRANTY Seller warrants this product, if used in accordance with all applicable instructions, to be free from original defects in material and workmanshipfor its lifetime. If the product should prove defective in material or workmanship within that period, Seller will repair or replace the product, in its sole discretion. Service under this Warranty can only be obtained by your delivering or shipping the product (with all shipping or delivery charges prepaid) to: Tripp Lite, 1111 W. 35th Street, Chicago, IL 60609. Seller will pay return shipping charges. Call Tripp Lite at (773) 869-1234 before sending any equipment back for repair.

THIS WARRANTY DOES NOT APPLY TO NORMAL WEAR OR TO DAMAGE RESULTING FROM ACCIDENT, MISUSE, ABUSE OR NEGLECT. SELLER MAKES NO EXPRESS WARRANTIES OTHER THAN THE WARRANTY EXPRESSLY SET FORTH HEREIN. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ALL IMPLIED WARRANTIES, INCLUDING ALL WARRANTIES OF MERCHANTABILITY OR FITNESS, ARE LIMITED IN DURATION TO THE WARRANTY PERIOD SET FORTH ABOVE; AND THIS WARRANTY EXPRESSLY EXCLUDES ALL INCIDENTAL AND CONSEQUENTIAL DAMAGES. (Some states do not allow limitations on how long an implied warranty lasts, and some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you. This Warranty gives you specific legal rights, and you may have other rights which vary from jurisdiction to jurisdiction.)

WARNING: The individual user should take care to determine prior to use whether this device is suitable, adequate or safe for the use intended. Since individual applications are subject to great variation, the manufacturer makes no representation or warranty as to the suitability or fitness of these devices for any specific application.

The policy of Tripp Lite is one of continuous improvement. Specifications are subject to change without notice.