Tripp Lite Power Inverters owner manual Hardwire AC Connection, Owner’s Manual Addendum

1111 W. 35th Street Chicago, IL 60609 USA

Customer Support: (773) 869-1234

www.tripplite.com

Owner’s Manual Addendum

PowerVerter® Hardwired Electrical Connections

& Dip Switch Settings

Power Inverters (120V, 60 Hz)

IMPORTANT SAFETY INSTRUCTIONS.This addendum and the accompanying manual contain information concerning the proper installation of Tripp Lite equipment. SAVE THESE INSTRUCTIONS.

Your PowerVerter is identical to the Inverter/Charger described in the accompanying owner’s manual with the two exceptions (Hardwire Connection and Dip Switch Settings) described here.

Hardwire AC Connection

Warning! Consult a qualified electrician and follow all applicable electrical codes and requirements for hardwire connection. Disconnect DC input and AC utility supply before attempting hardwiring.

Connection for Models with Hardwire Terminals

Remove the screws and cover plate over the hardwire terminal box. Remove the knockout covers closest to the desired electrical source and to your equipment. Attach ½" diameter conduits (user-supplied) to the knockouts and thread wires through. Connect the conduits to each other with the ground bond connection supplied.

Ground

•Connect the incoming and outgoing ground wires to the GROUND (green) terminal. 1

AC Input

•Connect the incoming hot wire to the input hot (brown) terminal. 2

•Connect the incoming neutral wire to the input neutral (blue) terminal. 3

AC Output

•Connect the outgoing hot wire to the output hot (black) terminal. 4

•Connect the outgoing neutral wire to the output neutral (white) terminal. 5

2

“FOR USE WITH COPPER WIRE ONLY”

HOT IN

NEUTRAL IN

GROUND IN

GROUND OUT

HOT OUT

NEUTRAL OUT

Tighten and affix strain relief. Replace cover plate and tighten screws.