Tripp Lite Series 5kVA owner manual Mounting Rack, Post Mounting, Post Telecom Mounting

Mounting (Rack)

Mount your equipment in either a 4-post or 2-post rack or rack enclosure.The user must determine the fitness of hardware and procedures before mounting. If hardware and procedures are not suitable for your application, contact the manufacturer of your rack or rack enclosure. The procedures described in this manual are for common rack and rack enclosure types and may not be appropriate for all applications.

WARNING!

Transformer modules are extremely heavy! Use caution while lifting and mounting! User must properly

stabilize the module while lifting and mounting!

4-Post Mounting

1Connect the two segments of each shelf A using the included attached screws and wing nuts B . Leave the screws slightly loose so that the shelves can be adjusted in the next step.

2Adjust each shelf to fit your rack, then mount them in the lowest available space of your rack with the screws, nuts and washers provided C . Note that the support ledges should face inward. Tighten the wingnuts that connect the shelf segments D .

Attach mounting ears E to the front mounting holes of your equipment F using

3the screws provided G . The ears should face forward.

Using an assistant, lift your equipment and slide it onto the mounting shelves.

4Attach your equipment to the rack by passing the screws, nuts and washers (user-provided) H through its mounting ears and into the rack rails.

	B
1	A	B

C
2	D

	F
3	E	G

H

4

2-Post (Telecom) Mounting

To mount your equipment in a 2-post rack, you must purchase a Tripp Lite 2-Post Rackmount Installation Kit (model: 2POSTRMKITWM, sold separately). See the Installation Kit's owner's manual for complete mounting instructions.

3