Tripp Lite Single-Phase 5kVA, Single-Phase 6kVA owner manual Power ON/OFF 5kVA models only

Power ON/OFF (5kVA models only)

1.Configure your UPS’s input and output: Put your UPS power module into setup mode by holding down both of its scroll buttons ( A and B ) at once. Scroll through the setup options (using A or B ) and select the appropriate setting for each of the following options using the “SELECT” button B .

•Input & Output Voltage: Select 200, 208 or 240 VAC.

•Output Frequency: Your UPS will autoselect 50 or 60 Hz to match the input.

•Economy Mode: Your UPS can provide on-line operation with zero transfer time. It can also operate in a more energy-efficient line-interactive mode. Select Economy On to put the UPS in line-interactive mode. Select Economy Off to put the UPS in on-line mode.

•After you have set these options, “exit” the setup mode with the scroll button A , then exit bypass mode by holding the ON button C down until you hear a beep.

2.Turn input to the UPS ON: Press and hold the power module's ON button C until you hear a beep to start your UPS in ON BATTERY mode. Note that some electronic equipment may draw more amps during startup; when starting from battery, consider reducing the ini- tial load on the UPS. Your UPS will perform a brief self-test and show the results on the LCD Display D . See "Startup Self-Test" in the "Operation" section for the display sequence.

3.To turn the UPS power module and transformer module (if used) OFF: Press the power module's OFF button F until you hear a beep. Your load will still be energized. The inverter is now off, but your UPS is not fully deactivated. The LCD Display D will show BYPASS MODE. Turn the power module's Output Breaker E OFF. Unplug the power module's AC input cord from the wall outlet. If a transformer module is used, unplug its connector cable from the power module. Your load will no longer be energized, and the LCD Display D will be dark.

E

5kVA Models

			D
C	A	B	F

5kVA Models (Front Panel)

18