Tripp Lite SMART750RM1U warranty Specifications, System Overview, Output, Input, Battery

Network interfaces support simultaneous communications via USB, DB9 serial and SNMPWEBCARD slot

Included PowerAlert UPS monitoring software supports safe unattended shutdown, monitoring and control via local connected servers, plus any number of additional servers over IP

Communications ports support on-battery, low-battery, power-restored, AC-voltage, DC-voltage, output current monitoring, battery charge current, battery capacity, internal UPS temperature, AC line frequency, timed inverter shutoff, activate self-test and load bank output power control

Built in Emergency Power Off (EPO) interface with cable

Sine wave output in AC and battery modes

Half load runtime of 24 minutes (375VA/225 watts)/Full load runtime of 7 minutes (750VA/450 watts)

Includes 6 NEMA 5-15R output receptacles arranged in 2 switchable single-outlet load banks

Integrated 2 bank switched PDU enables remote outlet management for load shedding or remote reboot of individual devices

3 stage metered LEDs offer current monitoring and battery charge level

Mains power and voltage regulation LEDs offer at-a-glance power status information

Front panel switches support self-test and alarm cancel functions

UPS ships fully assembled in full compliance with DOT regulations, no time consuming connection of internal batteries by user required

UL (USA), cUL (Canada), NOM (Mexico), FCC Class A (Emissions) listed

2 year manufacturer's product warranty, $250,000 Ultimate Lifetime Insurance

Specifications

SYSTEM OVERVIEW

Voltage compatibility	120 VAC
Frequency	60 Hz
compatibility
OUTPUT
Output VA	750
Output watts	450
Output nominal	120V AC
voltage
Output voltage	LINE MODE: Sine wave line voltage 120V (-21% +8%), BATTERY MODE: Sine wave output within 5% of 120VAC
regulation
Output frequency	LINE MODE: Passes line frequency of 60Hz +/-10% BATTERY MODE: Inverter output regulated to 60Hz +/-0.5Hz
regulation
Outlet quantity / type	6 NEMA 5-15R
Customized load	Includes 2 single-outlet load banks that support load shedding and remote reboot on demand of locked network
management	devices. Controllable via PowerAlert software to switch off optional loads, like monitors, to increase available runtime for
receptacles	servers and other critical devices.
Overload protection	15A input breaker
INPUT
Maximum input amps	7A
Input connection	NEMA 5-15P
type
Input cord length	10 ft., 14 gauge
Recommended	15A 120V
Electrical Service
BATTERY
Full load runtime	7 minutes (450 watts)
Half load runtime	24 minutes (225 watts)
DC system voltage	24 VDC
Typical battery	3-6 years, depending on usage
lifespan

Battery recharge rate

2-4 hours to 90%