Tripp Lite owner manual SUPDU001 C UL US, Owner’s Manual, Wiring Instructions

200301143 93-2114 SUPDU001 Owner’s Manual Revision.qxd 3/19/2003 11:46 AM Page 1

Owner’s Manual

SUPDU001 C UL US

Wiring Instructions

UL1788 Listed	1111 W. 35th Street • Chicago, IL 60609 USA
	Customer Support: (773) 869-1234 • www.tripplite.com
UPS Accessory

Connecting an SUPDU001 to the Output of a SmartOnline™ SU6K, SU10K, SU6000RT3U or SU10KRT3U

Important Safety Instructions! Save These Instructions!

WARNING! Before connection, make sure that your entire SmartOnline system is OFF (including transformer modules, where applicable), that all input and output breakers are switched OFF and that the system is not connected to AC power. (See SmartOnline Owner’s Manual.)

WARNING! SUPDU001 installation and wiring should only be made by a qualified electrician observing all applicable local, state and national electrical codes and requirements.

•Remove screws and open SUPDU001 case.

•Remove any one of the eight knockouts (either ½ or ¾ inch) around the edge of SUPDU001 case. Attach a user-supplied conduit connector.

•Attach a second user-supplied conduit connector to the terminal box cover of the SmartOnline UPS System.

•Connect user-supplied flexible, armored-cable conduit between the SUPDU001 and the SmartOnline UPS System terminal box.

•Run user-supplied wire through the conduit and make appropriate connections inside the SUPDU001 and inside the SmartOnline UPS System terminal box.

•Connect the colored wires to the SmartOnline’s terminal block as shown below. The brown wire can be connected for either 240V output or 208V output. Note: the desired output voltage MUST match the SmartOnline’s output voltage. (See SmartOnline Owner’s Manual.)

				Blue		Green		Brown	Brown
								(240V)	or (208V)
L1	L2	G		L3	N	G	N	L2	L1
	AC INPUT		208V	240V	120V	240V		120V
			INPUT
						208V

VOLTAGE SELECT

Copyright ©2003 Tripp Lite. All rights reserved. SmartOnline™ is a trademark of Tripp Lite.

200301143 93-2114