Tripp Lite TLP31SAT Important Safety Instructions, Installation, Save These Instructions

Important Safety Instructions

SAVE THESE INSTRUCTIONS

CAUTION! DO NOT connect to an ungrounded outlet. DO NOT use with 2-wire extension cords or adapters. This surge suppressor is designed for indoor use only. Install the surge suppressor away from heat-emitting appliances such as radiators or heat registers. Do not install where excessive moisture is present. Do not plug extension cords into it. Never install electrical, telephone, network or coaxial wiring during a lightning storm. Do not drill into any part of the housing or open the housing for any reason. There are no user-serviceable parts inside.

•Use of this equipment in life support applications where failure of this equipment can reasonably be expected to cause the failure of the life support equipment or to significantly affect its safety or effectiveness is not recommended. Do not use this equipment in the presence of a flammable anesthetic mixture with air, oxygen or nitrous oxide.

Installation

Your surge suppressor features a low profile, side outlet design, allowing it to be mounted behind a flat panel display while leaving the outlets open for use. One outlet and the coaxial jacks can be rotated independently up to 90 degrees.

Connect Your Surge Suppressor to the AC Power Line: Plug the surge suppressor directly into a 3-wire grounded, 120V AC outlet.

Check Your Surge Suppressor’s Diagnostic Indicator Light: Check your surge suppressor’s diagnostic LED prior to connecting your equipment. It will indicate operational status when the surge suppressor is plugged into a live 120V AC outlet.

“PROTECTED” LED: Indicates the surge suppression components are intact and providing complete protection against surges. If this LED does not illuminate, some of the surge suppression components are not functioning, and the unit should be replaced. Visit www.tripplite.com/support.

	2
13-06-102 93-32C4-EN.indd 2	6/14/2013 10:34:11 AM