Tripp Lite INT 3000 Quick Installation, Connect the UPS to an electrical, equipment into your UPS

Quick Installation

1	Connect the UPS to an electrical
	outlet and a computer to the

UPS.

•Unplug the computer’s power cord from both your AC outlet and the computer’s AC input.

•Insert the female plug of the computer’s cord (B) into your UPS’s AC input. Insert the male plug of your computer’s cord into your AC outlet.

•Insert the female plug of the power cord that came with your UPS (A) into the computer’s AC input. Insert the UPS cord’s male plug into any of your UPS’s female output receptacles.

2	Plug additional computers and
	equipment into your UPS.

Your UPS is designed to support only computer equipment. You will overload your UPS if you connect household appliances, laser printers or surge suppressors.

Cords and receptacle adapters are available from Tripp Lite to accommodate most outlet configurations. If rewiring is necessary, refer to the Wire Color-Code Chart in the Specifications section.

3 Turn your UPS ON. Figure 1

•Set the System Enable Switch (DIP Switch #4, UPS back panel) to the “ENABLE” (UP) position.

(See Figure 1)

This switch activates the battery charger and microprocessor.

The “” light will flash until you engage the ON/Standby Switch to activate the “ON” mode.

AB

SEE MANUAL

DIP Switch #4

(SystemEnableSwitch)

ENABLE

DISABLE

• Engage the momentary ON/Standby

Switch (UPS front panel) and release it	Figure 2 - ON/Standby Switch
to activate the “ON” mode and supply
power to the UPS receptacles.
(See Figure 2)

DB9 Port Connection (Optional) On Next Page . . .

3