Before Operation (continued)
Lift seat adjustment lever (Z) and slide seat forward or backward.
Z
| Models |
| 13074 & 13076 |
Fig. | |
|
|
Loosen adjustment knobs (ZZ), slide seat forward or backward.
ZZ
Auxilliary | Attachment Lift |
| |
Hydraulic Lever |
| ||
Lever (K) | Attachment/PTO Drive | ||
(Model 13076 Only) | |||
| Switch (X) | ||
(L) |
| ||
|
| ||
Light |
| Throttle (J) | |
Switch (E) |
|
| |
Cruise Control Switch |
| Travel | |
(Models 13074 & 13076) |
| Pedal (M) | |
(O) |
|
| |
Choke Lever (G) |
|
| |
|
| Ignition/Starter | |
Brake/Neutral |
| Switch (H) | |
|
| ||
Pedal (F) |
|
| |
|
| Parking Brake Lever (N) | |
Fig. |
|
|
Fig. | Model 13101 |
|
|
4. Visually Check
Check for and repair loose or missing screws, nuts, and damaged parts.
5. Check Battery
To connect the battery initially, remove the red (+) terminal cover from the (+) positive terminal and connect the red battery cable to this terminal. Tighten the hardware before sliding the boot over the terminal.
Next, remove the black
DANGER
BATTERIES PRODUCE EXPLOSIVE GASSES. KEEP OPEN FLAMES AND SPARKS AWAY. DO NOT SET TOOLS ACROSS TERMINALS.
BATTERY ELECTROLYTE CAN CAUSE SEVERE BURNS. EYE CONTACT CAN CAUSE BLINDNESS. ALWAYS WEAR EYE PROTECTION AND RUBBER GLOVES WHEN WORKING NEAR BATTERY. NEVER WEAR JEWELRY.
IF ELECTROLYTE CONTACTS SKIN OR EYES, RINSE IMMEDIATELY WITH WATER FOR AT LEAST 15 MINUTES. CALL PHYSICIAN IMMEDIATELY.
6. Check Tire Pressure
Front – | 12 to 14 PSI (82 to 96 kPa) |
Rear – | 8 to 10 PSI (55 to 68 kPa) |
7. Adjust Seat
Models 13074 & 13076 - To adjust seat, lift lever (Z, Fig.
Model 13101 - To adjust seat,loosen adjustment knobs (ZZ, Fig.
Tighten adjustment knobs.
8.Perform Electric Clutch Break-in Procedure
Perform this step before initial use and after extended storage.Before operating unit, start engine as instructed on page 16. With the engine running at full speed, engage and disengage attachment/PTO drive switch (X, Fig.
15
