Troy-Bilt 31AH9Q77766 warranty Setting Up Your Snow Thrower

NOTE: If the full range of speeds (forward and reverse) can not be achieved, refer to the “Making Adjustments” section.

4.a. Remove the internal cotter pin from the upper chute crank. Slide the upper chute crank into the sleeve on the lower chute crank.

b.Align the hole in the upper chute crank with the hole in the sleeve (If necessary, use a pair of pliers to assist in aligning holes). Insert the internal cotter pin through the holes to secure the chute crank. See Figure 3-4.

5.Remove lock nuts and screws securing one of the flange keepers to the chute assembly.

6.Place chute assembly onto chute base as shown in Figure 3-5, making sure that the notches engage with the spiral end of chute directional control.

7.Secure flange keeper removed earlier with lock nuts and screws. Tighten down nuts securing the other two flange keepers. See Figure 3-6.

8.If not already done, slip the cables that run from the handle panel to the discharge chute into the cable guide located on top of the engine. See Figure 3-7.

9.If not already done, wrap the wire of the head lamp wire harness down the right handle until the wire can be plugged into the engine alternator wire connector down on the engine. See Figure 3-8.

10.Normally the cable ties holding the steering cables against the handle are loosely installed on each side of the lower handle at the factory. Pull the cable ties tight to secure. Cut the excess from the ends of cable ties.

The extension cord is fastened with a cable tie to the rear of the auger housing for shipping purposes. Cut the cable tie and remove it before operating the snow thrower.

Figure 3-8

Figure 3-5

Figure 3-6

Figure 3-7

3

Setting Up

Your Snow

Thrower

IMPORTANT Prior to operating your snow thrower, refer to Auger Control Test in the Operation section. Read and follow all instructions carefully and perform all adjustments to verify your snow thrower is operating safely and properly.