Clutch Cable Adjustment

Before operating the tiller the adjustment of the forward clutch cables must be checked.

1.Disconnect and ground the spark plug wire against the engine.

2.Adjust the forward clutch cable by loosening the hex nut. See Fig. 3-8.

Cable Collar

Hex Nut

Figure 3-8

3.Turn the cable collar section one or two turns to increase or decrease tension on the cable. See Fig. 3-8.

4.Retighten the lock nut against the cable collar. See Fig. 3-8.

5.With the forward engagement handle in the neutral — released — position, pull the starter rope several times. The tines should not turn.

6.If they turn adjust the forward clutch cable to release tension using the previous steps in this section.

7.Check again for correct tension on the cable.

8.After tilling, if the tines stop moving, re-adjust the cables.

Set-Up

Gas & Oil Fill-Up

Service the Engine with gasoline and oil as instructed in the separate Engine Operator’s Manual packed with your tiller. Read the instructions carefully.

WARNING! Use extreme care when handling gasoline. Gasoline is extremely flammable and the vapors are explosive. Never fuel the machine indoors or while the engine is hot or running.

Section 3 — Assembly & Set-Up

 

9