Troy-Bilt 440 warranty Setup Adjustment, Adjustments, Cutting Height, Grass catcher

5.Follow steps below to assemble the grass catcher:

a.Place bag over frame so that its black plastic side is at the bottom. Check that the bag is turned right side out before assembling (warning label will be on the outside).

b.Slip plastic channel of grass bag over hooks on the frame. See Figure 3-5. All the plastic channels except center top of bag attach from outside of bag.

c.Attach center top of bag from inside of bag.

6.To attach the grass catcher. See Figure 3-6.

a.Lift rear discharge door.

b.Place grass catcher on the pivot rod. Let go of discharge door so that it rests on the grass catcher.

Adjustments

Cutting Height

An adjusting plate and thumb lever at each wheel provides cutting height adjustment. Each lever must be moved to the same position to ensure an even cut.

1.Pull the lever out and away from the mower. See Figure 3-7.

2.Move the lever forward or back for desired cutting height.

3.Release lever towards mower deck.

A

C

B

Figure 3-5: Assemble the grass catcher (if needed)

A

B

3

Setup and

Adjustment

WARNING

Never operate mower unless the hooks on the grass catcher are firmly seated on the pivot rod and the rear discharge door rests firmly against top of

the grass catcher.

Figure 3-6: Attach the grass catcher.

2

1

3

Figure 3-7: Use lever at each wheel to adjust cutting height.

IMPORTANT: This unit is shipped without gasoline or oil in the engine. Fill up gasoline and oil as instructed in the accompanying engine manual BE- FORE operating your mower.